Engineering, 20.08.2019 18:30 twistedgamerhd12

A60 v dc wind turbine is hooked up to charge a battery bank consisting of four 15 v batteries in series. the wind is not blowing, but the batteries must supply 2 loads. one is a light bulb, rated at 250 w at 60 v; the other is a heater which is rated at 2,000 w at 60 v. the loads are in parallel. the batteries may be considered to be constant 15 v voltage sources, with an internal series resistance of 0.05 ohm each a) find i) the resistance of each load and ii) the total resistance b) how much power is actually supplied to the loads? how does that power compare to that which is expected? c) how much power is lost in the internal resistance of the batteries? what fraction is this of the total power coming from the batteries? (ignore the effect of temperature on resistance of filament and heating elements.)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

You know the right answer?

A60 v dc wind turbine is hooked up to charge a battery bank consisting of four 15 v batteries in ser...

Questions