Engineering, 07.08.2019 19:30 cbogrett

Asoft surface cone clutch must handle 1865 in-lb of torque at 1250 rpm. the large diameter of the clutch is 13.75 in, the cone pitch angle is 6.25°, the face width is 2.50 in, and the coefficient of friction is 0.20. determine: a. the axial force required to transmit the torque b. the axial force required to engage the clutch, fe, engagement taking place when the clutch is not rotating c. the average normal pressure on the contact surfaces when the maximum torque is being transmitted d. the maximum normal pressure assuming uniform wear

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the main objective of using reheat rankine cycle?

Answers: 3

Answer

You know the right answer?

Asoft surface cone clutch must handle 1865 in-lb of torque at 1250 rpm. the large diameter of the cl...

Questions