subject
Engineering, 01.08.2019 08:10 trentvw1174

If a tail light circuit is drawing 6 amperes of current from the 12 volt battery, then
the tail light circuit resistance is (a) 2 watts (b) 2 ohm (c) 2 ohms (d) 1 watt.
a vehicle may use (a) diodes in the alternator (b) transistors in the ignition system (c) integrated circuits in the engine control module (d) all of these.
for each of the following, circle t if the statement is true, circle f if it is false.
t
f
an automotive shop is subject to safety regulations regarding employee exposure
to hazardous chemicals; however, used transmission fluid, antifreeze, and brake
fluid may legally be poured down a drain.
37. t
f
high performance engines may be designed with larger intake valves, an efficient
exhaust system, and use a supercharger to raise the volumetric efficiency for more
torque at higher rpms.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
You know the right answer?
If a tail light circuit is drawing 6 amperes of current from the 12 volt battery, then
the tail...
Questions
Questions on the website: 13722360