Engineering, 31.07.2019 00:20 jaymieordonez8751

Asmall wind tunnel in a university’s undergraduate fluid flow laboratory has a test section that is 15 by 11 inches in cross section and is 4.0 ft long. its maximum speed is 145 ft/s. some students wish to build a model 18-wheeler to study how aerodynamic drag is affected by rounding off the back of the trailer. a full-size (prototype) tractor-trailer rig is 52 ft long, 8.33 ft wide, and 12 ft high. both the air in the wind tunnel and the air flowing over the prototype are at 80 °f and atmospheric pressure. what is the largest scale model they can build to stay within the rule-of-thumb guidelines for blockage and what are the dimensions of the model truck in inches? the width of the model truck is in. the height of the model truck is in. the length of the model truck is i

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.

Answers: 1

Answer

You know the right answer?

Asmall wind tunnel in a university’s undergraduate fluid flow laboratory has a test section that is...

Questions