Engineering, 26.07.2019 17:20 trint4
In machining, if the cost to purchase/regrind the cutting tool=$0.00, the optimum speed for machining time minimization would be different from the optimum speed for production cost minimization. i. true. il. false. ii. the statement is true or false depending on other conditions. iv. not sure. i will take the penalty
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)
Answers: 2
Engineering, 06.07.2019 03:20
An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler
Answers: 2
You know the right answer?
In machining, if the cost to purchase/regrind the cutting tool=$0.00, the optimum speed for machinin...
Questions
Social Studies, 04.03.2021 07:10
English, 04.03.2021 07:10
English, 04.03.2021 07:10
Mathematics, 04.03.2021 07:10
Physics, 04.03.2021 07:10
Chemistry, 04.03.2021 07:10
Business, 04.03.2021 07:10
Mathematics, 04.03.2021 07:10
History, 04.03.2021 07:10
Physics, 04.03.2021 07:10
