Engineering, 19.07.2019 23:40 20warriorsoul14

Fluid power is the muscle of automation because of advantages in the following four major categories(choose four) a. ease and accuracy of control b. constant force or torque c. simplicity, safety, economy d. instantly reversible motion. e. automatic protection against overloads f. multiplication of force

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 06.07.2019 02:30

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

Answer

Engineering, 06.07.2019 05:10

An ideal vapor-compression refrigeration cycle is employed to maintain a building temperature of 23°c when the outside temperature is 37°c. the cycle operates at steady state using ammonia as the working fluid. the mass flow rate of the refrigerant is 15 kg/min. the refrigerant enters the compressor at 1.5 bar and 10 °c. the condenser pressure is 20 bar and the temperature at the condenser exit is 45 °c. determine (a) the compressor power in kw. (b) the refrigeration capacity in tons. (c) the coefficient of performance. d) the maximum theoretical coefficient of performance.

Answers: 2

Answer

You know the right answer?

Fluid power is the muscle of automation because of advantages in the following four major categories...

Questions