Afunctional gauge is to be made to test a hole on a plate. the hole is supposed to be 1 in to 1.2 in diameter, and perpendicular to the base of the plate by no more than 0.05 in (diametral perpendicularity tolerance) at maximum material condition. what should the diameter of the go and the no go pins be? select the appropriate answer below a. go pin diameter 0.95 in, no go pin diameter 1.45 in b. go pin diameter 1.0 in, no go pin diameter 1.2 in. c. go pin diameter 12 in, no go pin diameter 1.0in. d. go pin diameter 1.45 in, no go pin diameter 0.95 in. e. none of the above.