Engineering, 19.07.2019 01:30 Cjohnston742

Water is drawn steadily by a pump at a volumetric flow rate of 0.8 m/min through a pipe with a 10 cm diameter inlet. the water is delivered to a tank placed at a height of 10 m above the pipe inlet. the water exits through a nozzle having a diameter of 2.5 cm. water enters at 25°c and 1 atm pressure but there is no significant change in pressure and temperature at exit. six percent of the power input to the pump is dissipated in the form of heat into the surroundings. take the value of acceleration due to gravity (g) equal to 9.8 m/s determine (a) the velocity of the water at the inlet and exit and (b) the power required by the pump.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

You know the right answer?

Water is drawn steadily by a pump at a volumetric flow rate of 0.8 m/min through a pipe with a 10 cm...

Questions

Engineering, 03.09.2020 06:01

A standard 20° pressure angle, 20 tooth pinion with a diametral pitch of 12 rotates at 1776 rpm driving a mating gear at 740 rpm. a) How many teeth ar...

Engineering, 03.09.2020 06:01

Which conditions are required for nuclear fusion to begin...