subject
Engineering, 19.07.2019 00:10 zack66828

The velocity of water in a square duct (0.4 m sides) is 0.5 m/sec. the flow in the d full. is this flow laminar, turbulent, uniform or non-uniform?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
question
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
You know the right answer?
The velocity of water in a square duct (0.4 m sides) is 0.5 m/sec. the flow in the d full. is this f...
Questions
question
Mathematics, 09.12.2020 14:00
question
German, 09.12.2020 14:00
question
Mathematics, 09.12.2020 14:00
Questions on the website: 13722360