Engineering, 18.07.2019 03:20 Anderson0300
Determine the lubrication parameters with u=0.03350 pa. s, n =600rpm, 20mm, l=40 the average oil film temperature in oil bath and moving air condition and ambient temperature 30°c, use at least 3 iterations. state whether you should change the oil. what happens if you instead use sae 70 at 80°c with the shaft still rotating at the same n? compare each values of each parameter.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 04.07.2019 19:20
Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.
Answers: 3
You know the right answer?
Determine the lubrication parameters with u=0.03350 pa. s, n =600rpm, 20mm, l=40 the average oil fil...
Questions
Mathematics, 13.07.2021 01:00
History, 13.07.2021 01:00
English, 13.07.2021 01:00
Mathematics, 13.07.2021 01:00
Mathematics, 13.07.2021 01:00
Mathematics, 13.07.2021 01:00
English, 13.07.2021 01:00
Biology, 13.07.2021 01:00
Mathematics, 13.07.2021 01:00
