Engineering, 17.07.2019 23:40 drivinghydra

An arc-welding operation is used to weld aluminum substrates with a heat transfer factor 0.80. the aluminumm melting temperature is im -930°k and melting factor - 0.40. the aluminum substrates are welded using a fillet weld with a cross-sectional area 25.0 mm2 a)-if the welding power used is 3200 w, determine the travel speed at which the welding operation can be accomplished. b)-if the metal to be welded is high carbon steel with melting factor 0.60 and melting temperature tm 1650°k. determine the welding power required to weld the high carbon steel substrates at the same travel speed obtained in (a). c)-from the power result in part (b), if the welding voltage 20 volts, determine the value for the current in the operation.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

You know the right answer?

An arc-welding operation is used to weld aluminum substrates with a heat transfer factor 0.80. the a...

Questions