Engineering, 11.07.2019 04:10 izabellehannah7165
If there are 20 lbs. on one side of a fulcrum (with equal lengths on both sides), which of the following combinations of weights would be enough to balance the loads on that fulcrum
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
If there are 20 lbs. on one side of a fulcrum (with equal lengths on both sides), which of the follo...
Questions
Mathematics, 04.04.2021 20:10
Mathematics, 04.04.2021 20:10
Chemistry, 04.04.2021 20:10
English, 04.04.2021 20:10
Mathematics, 04.04.2021 20:10
History, 04.04.2021 20:10
English, 04.04.2021 20:10
Mathematics, 04.04.2021 20:10
Mathematics, 04.04.2021 20:20
History, 04.04.2021 20:20
Biology, 04.04.2021 20:20
History, 04.04.2021 20:20
Mathematics, 04.04.2021 20:20
English, 04.04.2021 20:20
Health, 04.04.2021 20:20
