Engineering, 11.07.2019 03:20 glori1647
A90 mm diameter cylindrical part is turned on a lathe at 600 rpm. if the depth of cut is 5 mm, feed rate is 0.2 mm/rev, and specific energy of the workpiece material is 3.5 w? s/mm3, calculate the minimum power of the lathe.
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
A90 mm diameter cylindrical part is turned on a lathe at 600 rpm. if the depth of cut is 5 mm, feed...
Biology, 26.10.2020 22:30
Mathematics, 26.10.2020 22:30
Social Studies, 26.10.2020 22:30
Mathematics, 26.10.2020 22:30
Mathematics, 26.10.2020 22:30
Arts, 26.10.2020 22:30
History, 26.10.2020 22:30
Mathematics, 26.10.2020 22:30
Mathematics, 26.10.2020 22:30
Social Studies, 26.10.2020 22:30
Chemistry, 26.10.2020 22:30