Engineering, 11.07.2019 02:20 Kekkdkskdkdk

Agas power cycle has air entering at 0.7 bar and 260 k. the compressor pressure ratio is 25: 1 and its outlet temperature is 720 k. the combustor heats the air to 1700 k and the turbine exhaust temperature is 800 k. a. sketch the three processes on a p-h diagram. b. calculate the enthalpy change for each component. report your answers in kj/kg. c. calculate the entropy change for each component. report your answer in kj/kg-k. d. determine the entropy generation for each component. report you answer in kj/kg-k. e. based on your answers to c, which component(s) would you focus engineering redesign/performance improvement efforts?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

Agas power cycle has air entering at 0.7 bar and 260 k. the compressor pressure ratio is 25: 1 and i...

Questions