subject
Engineering, 28.01.2020 11:31 mandi795

In areas where the air temperature remains below o°c for prolonged periods of time, the freezing of water in underground pipes is a major concern. fortunately, the soil remains relatively warm during those periods, and it takes weeks for the subfreezing temperatures to reach the water mains in the ground. thus, the soil effectively serves as an insulation to protect the water from subfreezing temperatures in winter. the ground at a cold location is covered with snow pack at -10°c for a continuous period of two months, and the average soil properties at that location are k 0.4 w/m-k and a 0.15 x10m/s. each pipe of the system is 30 m long with a diameter of 10 cm. assuming an initial uniform temperature of 10°c for the ground and pipe surface, determine: a) the minimum burial depth to prevent the water pipes from freezing, and b) the conduction shape factor and steady rate of heat transfer at the minimum burial depth.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
In areas where the air temperature remains below o°c for prolonged periods of time, the freezing of...
Questions
question
Mathematics, 28.02.2020 19:35
Questions on the website: 13722361