Engineering, 11.07.2019 01:20 angie249
What is the factor of safety in designing a rod with diameter of 5 cm, where the rod is loaded by normal force of 250 kn, and the material of the rod is carbon steel which has yield strength of 310 mpa, and ultimate tensile strength of 565 mpa?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 19:20
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
You know the right answer?
What is the factor of safety in designing a rod with diameter of 5 cm, where the rod is loaded by no...
Questions
Physics, 29.10.2020 20:10
Mathematics, 29.10.2020 20:10
Mathematics, 29.10.2020 20:10
Mathematics, 29.10.2020 20:10
Mathematics, 29.10.2020 20:10
History, 29.10.2020 20:10
Mathematics, 29.10.2020 20:10
History, 29.10.2020 20:10
