Engineering, 11.07.2019 01:10 ljohnson135
The yield stress of a tension specimen machined from a 2-m wide by 0.6-cm thick copper sheet is 145 mpa. the sheet is rolled further with an applied tensile force in the plane of the sheet of 0.22 mn. what roll pressure is needed to just cause yielding? you may ignore friction between the metal and the rolls. for rolling, the deformation occurs by plane-strain in which there is no increase in the width of the sheet. you may also assume that for plastic flow the poisson's ratio v 0.5, and the copper obeys von mises criterion
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
Engineering, 04.07.2019 19:10
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
The yield stress of a tension specimen machined from a 2-m wide by 0.6-cm thick copper sheet is 145...
Questions
Biology, 11.04.2020 00:52
Biology, 11.04.2020 00:52
Mathematics, 11.04.2020 00:52
Mathematics, 11.04.2020 00:53
Mathematics, 11.04.2020 00:53
Mathematics, 11.04.2020 00:53
Advanced Placement (AP), 11.04.2020 00:53
Health, 11.04.2020 00:53
Mathematics, 11.04.2020 00:53
Spanish, 11.04.2020 00:53
