subject
Engineering, 11.07.2019 01:10 mbol7123

Consider a spent nuelear fuel rod of constant thermal conductivity k, perimeter p, length l, and uniform cross-sectional area ac. energy is released at a uniform rate q in w/within the rod. the left end of the rod is insulated and the right side is held at to. the outer surface of the rod is immersed in water at a temperature t and known convection coefficient h. the temperature gradients are small in all directions other than the x-direction and steady-state conditions apply. a) draw a differential control volume and show all energy transfers. b) applying the 15t law of thermodynamics, derive the governing differential equation for the temperature distribution t(a) in the rod in terms of x. q. ac, k, h, p and t- and state the boundary conditions at x = 0 and x = l.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
question
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
question
Engineering, 04.07.2019 19:20
Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?
Answers: 1
You know the right answer?
Consider a spent nuelear fuel rod of constant thermal conductivity k, perimeter p, length l, and uni...
Questions
question
Mathematics, 19.02.2021 21:50
question
Mathematics, 19.02.2021 21:50
question
Chemistry, 19.02.2021 21:50
question
Arts, 19.02.2021 21:50
question
Mathematics, 19.02.2021 21:50
Questions on the website: 13722363