Engineering, 11.07.2019 01:10 Adithya27

The boeing 747 is an air plane often equipped with four pratt and whitney jt9d engines that can each offer 193.50 kn of thrust. the air plane has a cruise speed of 907 km/hour, and typical cruise altitudes are of 11 km where the air temperature is -56 °c and density is 0.36 kg/m^3. its coefficient of drag at cruise conditions is 0.031, using the total wing area of 511m^2 as the reference area. its maximum take-off mass is 333000 kg a) what is the plane's coefficient of lift during cruise at its maximum take-off mass? b) what percentage of maximum thrust is required to keep the plane cruising? c) what is the plane's maximum angle of ascent? use the coefficient of lift calculated in part a). the following may be of : a cos(x) + bsin(x) = r cos(x-a) where r = va2+52 and a = tan(b/a)

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

You know the right answer?

The boeing 747 is an air plane often equipped with four pratt and whitney jt9d engines that can each...

Questions