Engineering, 04.07.2019 18:10 samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless....
English, 11.10.2019 22:50
English, 11.10.2019 22:50
Chemistry, 11.10.2019 22:50
Mathematics, 11.10.2019 22:50
Health, 11.10.2019 22:50
Social Studies, 11.10.2019 22:50
Mathematics, 11.10.2019 22:50
Mathematics, 11.10.2019 22:50
Mathematics, 11.10.2019 22:50
Health, 11.10.2019 22:50
English, 11.10.2019 22:50
Health, 11.10.2019 22:50
English, 11.10.2019 22:50