Engineering, 04.07.2019 18:10 Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Which of the following components of a pid controlled accumulates the error over time and responds t...
Mathematics, 22.11.2020 18:30
Social Studies, 22.11.2020 18:30
Geography, 22.11.2020 18:30
Mathematics, 22.11.2020 18:30
Mathematics, 22.11.2020 18:30
English, 22.11.2020 18:30
English, 22.11.2020 18:30
Mathematics, 22.11.2020 18:30
Chemistry, 22.11.2020 18:30
Social Studies, 22.11.2020 18:30
History, 22.11.2020 18:30
Mathematics, 22.11.2020 18:30
Mathematics, 22.11.2020 18:30
Chemistry, 22.11.2020 18:30
Biology, 22.11.2020 18:40