According to popular science Web sites, the scientific process of digital forensics normally starts with a(n) .

The reset circuit used on the four 3-bit counters analyzed in this activity reset the counts to zero (000). it makes sense for the up-counters to start at zero (000), but the down-counters should start at seven (111). what would you need to change so that the 3-bit binary down counter with j/k flip-flops you just created would reset to seven (111)?

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Per the municipal solid waste report, what are the most common sources of waste (trash