"write a program to play and score the paper-rock-scissor game. each of two users types in either p, r, or s. the program then announces the winner as well the basis for determining the winner: paper covers rock, rock breaks scissors, scissors cut paper, or nobody wins. be sure to allow the users to use lowercase as well uppercase letters. your program should include a loop that lets the user play again until the user says she or he is done."

Draw the hierarchy chart and design the logic for a program that calculates service charges for hazel's housecleaning service. the program contains housekeeping, detail loop, and end-of-job modules. the main program declares any needed global variables and constants and calls the other modules. the housekeeping module displays a prompt for and accepts a customer's last name. while the user does not enter for the name, the detail loop accepts the number of bathrooms and the number of other rooms to be cleaned. the service charge is computed as $40 plus $15 for each bathroom and $10 for each of the other rooms. the detail loop also displays the service charge and then prompts the user for the next customer's name. the end-of-job module, which executes after the user enters the sentinel value for the name, displays a message that indicates the program is complete.

Me with this program in c++ ! computers represent color by combining sub-colors red, green, and blue (rgb). each sub-color's value can range from 0 to 255. thus (255, 0, 0) is bright red. (130, 0, 130) is a medium purple. (0, 0, 0) is black, (255, 255, 255) is white, and (40, 40, 40) is a dark gray. (130, 50, 130) is a faded purple, due to the (50, 50, 50) gray part. (in other word, equal amounts of red, green, blue yield gray).given values for red, green, and blue, remove the gray part. ex: if the input is 130 50 130, the output is: 80 0 80. thus, find the smallest value, and then subtract it from all three values, thus removing the gray.

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to