3. When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? A. Series

B. Parallel

C. Control

D. Line

B. Parallel

Explanation:

When using the ohmmeter function of a digital multimeter, the leads are placed parallel to the component being tested. The digital multimeter is placed parallel to the component because, current has to flow into the component so as to be able to measure its resistance. Without the flow of current in the component, the resistance could not be measured.

If the component were placed in series, there would be no way to close the circuit because, we need a closed circuit so as to measure the resistance and use the ohmmeter function of the digital multimeter.

Only a parallel connection would close the circuit.

So, B is the answer.

i just joined so i'm not sure but you may need to verify your email if you haven't