Clifford created a table using openoffice writer and entered some information into the table. later, he needed to add more rows into the table. where can clifford specify the location of the new rows for the existing table?
a. the size section of the insert table dialog box
b. the name textbox of the insert table dialog box
c. the position section of the insert rows dialog box
d. the number textbox of the insert rows dialog box

Scientists have changed the model of the atom as they have gathered new evidence. one of the atomic models is shown below. what experimental evidence led to the development of this atomic model from the one before it? a few of the positive particles aimed at a gold foil seemed to bounce back. the colors of light emitted from heated atoms had very specific energies. experiments with water vapor showed that elements combine in specific proportions. cathode rays were bent in the same way whenever a magnet was brought near them.

Why do we mark tlc plates with pencil and not with pen

In a heat transfer course, we can derive the equation for the temperature distribution in a flat rectangular plate. in this example, we will look at a plate at steadystate with three sides being held at t1, and one side held at t2. the temperature for any location on the plate, t(x,y), can be calculated by where create a function (prob3_5) that will take inputs of vectors x and y in feet, scalar n, scalars l and w in feet and scalars t1 and t2 in degrees fahrenheit. it will output a matrix t which is the temperature of each x and y locations. t will have the number of columns equal to the number of elements in x and rows equal to the number of elements in y. though this can be done without loops (perhaps more efficiently), your program must use a nested loop.