Create an FSM that will connect with the 4-bit Counter. It has a switch input that allows the choice of two maximum values (you specify what they are, but both must be greater than 5). The FSM will do the following: A. It will reset the counter. B. It will continuously increment the counter to the chosen max value, then decrement the counter to 0. So, if switch is in ON state then the FSM will cause the counter to increment up to your 1st specified value and then decrement to 0. If the switch is on OFF state then the counter will increment up to your 2nd value and then decrement to 0. (Note: This is repeated continuously, so your FSM will need to constantly check the max value setting as it increments the counter!) C. Output need to be display on the Seven segment display.