11. Look at this code: myVar int(input("Give input: "))
What happens if the human enters "Salad"?

Kyle wants to access his school’s home page. how can he do this?

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it must not appear in the factorization. sample runs are given below. note that if the power of a prime is 1, then that 1 must appear in t

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.