subject

If you were to select pin gages to check a hole with a 0.625" dia. +0.002"/-0.003", what pin sizes should be used for the go and no-go gages? Provide a three-decimal answer.

ansver
Answers: 2

Another question on Computers and Technology

question
Computers and Technology, 22.06.2019 22:40
Least square fit to polynomial write a function leastsquarefit3pol that solves a linear system of equations to find a least squares fit of a third order polynomial to an experimental data set given as two row arrays. the function leastsquarefit3pol must explicitly solve a set of linear equations and cannot use polyfit. there should be no restriction on the size of the problem that can be solved.
Answers: 1
question
Computers and Technology, 23.06.2019 01:00
Complete the sentence about a presentation delivery method
Answers: 2
question
Computers and Technology, 23.06.2019 09:30
Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e.g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)
Answers: 3
question
Computers and Technology, 23.06.2019 18:30
Where can page numbers appear? check all that apply. in the header inside tables in the footer at the bottom of columns at the top of columns
Answers: 1
You know the right answer?
If you were to select pin gages to check a hole with a 0.625" dia. +0.002"/-0.003", what pin sizes s...
Questions
question
Mathematics, 05.10.2019 21:00
question
History, 05.10.2019 21:00
question
Mathematics, 05.10.2019 21:00
Questions on the website: 13722363