Computers and Technology, 23.11.2020 23:00 josephicarusmarrujo

Tricia is managing tasks that have been assigned to her. She needs to enter mileage information in relation to a project which command must she use to access this option?

Answers: 3

Show answers

Another question on Computers and Technology

Computers and Technology, 23.06.2019 03:00

Jason, samantha, ravi, sheila, and ankit are preparing for an upcoming marathon. each day of the week, they run a certain number of miles and write them into a notebook. at the end of the week, they would like to know the number of miles run each day, the total miles for the week, and average miles run each day. write a program to them analyze their data. your program must contain parallel arrays: an array to store the names of the runners and a two-dimensional array of five rows and seven columns to store the number of miles run by each runner each day. furthermore, your program must contain at least the following functions: a function to read and store the runners’ names and the numbers of miles run each day; a function to find the total miles run by each runner and the average number of miles run each day; and a function to output the results. (you may assume that the input data is stored in a file and each line of data is in the following form: runnername milesday1 milesday2 milesday3 milesday4 milesday5 milesday6 milesday7.)

Answers: 3

Answer

Computers and Technology, 23.06.2019 09:30

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

Answer

Computers and Technology, 23.06.2019 19:30

You can apply several different worksheet themes from which tab?

Answers: 1

Answer

Computers and Technology, 23.06.2019 20:50

3.11.3 quiz: comparing and analyzing function typesquestion 4 of 102 pointswhat can you say about the y-values of the two functions f(x) = 3x2-3 andg(x)=2* - 3?

Answers: 2

Answer

You know the right answer?

Tricia is managing tasks that have been assigned to her. She needs to enter mileage information in r...

Questions