1. Draw the Direct Current (DC) motor position control simulation model with Proportional Integral Derivative (PID) controller in the Simulink environment. 2. Simulate the model, first with only one proportional (P) controller, and then with only one integral (I) controller. Simulate with Proportional Derivative (PD) controller. Check the Set-Point Weight Effect on dynamic properties of the speed control system with PD controller.
3. Response to Load Disturbance with PD and PID controllers In the report 1.

Octothorpe is another name for what common computer keyboard symbol?

Drag the tiles to the correct boxes to complete the pairs. match the errors with their definitions. #name #value #ref when a formula produces output that is too lengthy to fit in the spreadsheet cell arrowright when you enter an invalid cell reference in a formula arrowright when you type text in cells that accept numeric data arrowright when you type in a cell reference that doesn’t exist arrowright reset next

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."