A network administrator is examining a RIPv2 routing table and notices that several subnets are advertised in individual entries. What can an administrator do to enable a RIPv2 router to automatically group multiple directly attached subnetworks into a single network statement?

A. Use the passive-interface command. B. Use the auto-summary command. C. Use the default-information originate command. D. Use the version 2 command.

Monica and her team have implemented is successfully in an organization. what factor leads to successful is implementation? good between different departments in an organization leads to successful is implementation.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

Write a program that reads a set of floating-point values. ask the user to enter the values, then print • the average of the values. • the smallest of the values. • the largest of the values. • the range, that is the difference between the smallest and largest. of course, you may only prompt for the values once.