Aforensic investigator at a crime lab is performing a forensic analysis of a hard drive that was brought in by state troopers. they make a mistake by using the wrong forensic tool during their forensics examination. what should the investigator do? a. document the mistake and workaround the problem. b. document the mistake and press on with remaining tasksc. disclose the mistake and assess another area of the hard drived. disclose the mistake and preserve the chain of custody

Problems: 1. using textbooks, reference books, and internet as your source of research, draw the following microprocessor microarchitectures i. intel 8086 ii. motorola 68000 i atmel atmega32 iv. mips single cycle v. arm cortex-m3 write an hdl module for a hexadecimal seven-segment display decoder. the input is 4-bit binary representing a hex number (0-f), and the output is 8-bit seven segment display bits (a-h). thus, the decoder must handle the digits 10 - 15 to display a-f respectively, in addition to 0-9 numbers. 2. design a 4-bit left and right rotator (both outputs). first sketch schematic diagrams of your design. then implement your design using hdl coding. 3. 4. design a modified priority encoder that receives an 8-bit input, a7: 0 and produces a 3-bit output, y2o. y indicates the most significant bit of the input that is true. y should be 0 if none of the inputs are true. give a simplified boolean equation, sketch a schematic, and write an hdl code. 5.write an 8: 1 multiplexer module called mux8 with selection inputs s, data input d, and data output y. data input (d) and data output (v) are 32-bit wide

Larry sent an email to andy. andy didn't open larry's email but still understood what the message was. how did andy determine the message without opening the email?

Alook-up table used to convert pixel values to output values on a monitor. essentially, all pixels with a value of 190 or above are shown as white (i.e. 255), and all values with a value of 63 or less are shown as black (i.e. 0). in between the pixels are scaled so that a pixel with a value p is converted to a pixel of value 2/127 −+3969). if a pixel has a value of 170 originally, what value will be used to display the pixel on the monitor? if a value of 110 is used to display the pixel on the monitor, what was the original value of the pixel?