Your data-recovery strategy must meet the following requirements:
 back up all data files and folders in c: \data.
 restore individual files and folders in c: \data.
 ensure that data is backed up to and restored from external media.
what should you do?
a. use the previous versions tab to restore the files and folders.
b. use the system restore feature to perform backup and restore operations.
c. use the ntbackup utility to back up and restore individual files and folders.
d. use the backup and restore center to back up and restore files.

What is stored in str after the following code executes? string str = "computer science"; int i = 0; while (i < 8) { if (str.indexof("m") < i) { str = str.substring(0, 2) + str; } i += 2; } computer science cocomputer science cococomputer science cocococomputer science computer scienceco

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.