Use the rtl design process to create an alarm system that sets a single-bit output "alarm" to ‘1’ when the average temperature of four consecutive samples meets or exceeds a user-defined threshold value. a 32-bit unsigned input "ct" indicates the current temperature, and a 32-bit unsigned input "wt" indicates the warning threshold. samples should be taken once every two clock cycles. a single-bit input "clr" when set to 1 disables the alarm and the sampling process. when "clr" is released, the previous saved temperature samples are cleared to zero. a

Many everyday occurrences can be represented as a binary bit. for example, a door is open or closed, the stove is on or off, and the fog is asleep or awake. could relationships be represented as a binary value? give example.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

What is a programming method that provides for interactive modules to a website?