Computers and Technology, 08.11.2019 18:31 bankskry

Which term defines a star system with two stars?

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 08:10

Technician a says that if a valve is open when a piston rises to the very top of a cylinder, the piston may actually strike the valve head and cause serious engine damage. technician b says if the camshaft is located in the engine block, then the engine is called an overhead valve engine, ohv engine, or an in-block camshaft. who is right? a. b only b. both a and b c. a only d. neither a nor b

Answers: 3

Answer

Computers and Technology, 22.06.2019 20:40

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

Answers: 2

Answer

Computers and Technology, 22.06.2019 21:00

So im doing this school challenge and the teachers said whats the average text a student gets a day so i need to get about 20 in a day but dont know how can you guys 2163371293

Answers: 2

Answer

Computers and Technology, 23.06.2019 19:00

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangleâ€™s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangleâ€™s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circleâ€™s radius, the rectangleâ€™s length or width, or the triangleâ€™s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."