The two variables loaded into the workspace are muxsignal and fs. the raw data stream of the music signals is stored in muxsignal while fs contains the sampling frequency. determine the sampling period, store it inside the variable ts and then use this to construct a time domain vector, t, that corresponds to muxsignal. plot muxsignal against this time vector.

Acetylene is a gas which burns rapidly on its own, and is considered highly explosive. a) true b) false

In a response of approximately 50 words, explain why it would be essential for the successful a/v technician to participate in additional coursework, presentations and seminars offered by equipment manufacturers as well as annual conferences attended by colleagues in the industry.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."