Computers and Technology, 31.08.2019 00:30 sodaswann

What command prompts should be used to assign an ip address to:
a - cisco router
b - cisco switch
c - local pc

Answers: 1

Show answers

Answers

Answer from: dontcareanyonemo

...

Explanation:

A. Cisco Router

1. Enter global configuration mode using the next commands:

Router>enable

Router#configure terminal

2. enters the configuration mode for a Gigabit Ethernet interface on the router using this command:

interface gigabitethernet slot/port

Example:

Router(config)# interface gigabitethernet 0/1

3. Set the IP address and subnet mask for the specified GE interface using this command:

ip address x.x.x.x y.y.y.y

Example:

Router(config-if)# ip address 192.168.0.1 255.255.255.0

4. Finally, enable the GE interface, changing its state from administratively down to administratively up:

Router(config-if)# no shutdown

Exit configuration mode for the GE interface and returns to global configuration mode using this:

Router(config-if)# exit

B. Cisco Switch

Normally Cisco switches forward Ethernet frames without any configuration. so you don´t need to assign them an IP address, but to perform switch management over the network or use protocols such as SNMP, the switch will need to have an IP address. Here are the steps:

1. Enter global configuration mode using the next commands:

Switch>enable

Switch#configure terminal

2. Enter the VLAN 1 configuration mode:

Switch(config)#int vlan 1

3. Assign an IP address with the ip address IP ADDRESS SUBNET MASK interface subcommand.

Example:

Switch(config-if)#ip address 10.0.0.1 255.0.0.0

4. Enable the VLAN 1 interface with the no shutdown interface subcommand.

example:

SW1(config-if)#no shutdown

C. Local PC

1. Click Start Menu > Control Panel > Network and Sharing Center or Network and Internet > Network and Sharing Center.

2. Click Change adapter settings.

3. Right-click on Wi-Fi or Local Area Connection.

4. Click Properties.

5. Select Internet Protocol Version 4 (TCP/IPv4).

6. Click Properties.

7. Select Use the following IP address.

8. Enter the IP address, Subnet mask, Default gateway, and DNS server.

9. Click OK.

Answer from: Quest

The correct answer would be a.

Answer from: Quest

the answer is b. executive summary. a management summary, or executive summary, is a short article or section of a document, produced for business purposes, that condenses a longer report or proposal or a group of related reports in such a way that readers can rapidly become familiar with a large body of material without having to read it all.

Another question on Computers and Technology

Computers and Technology, 22.06.2019 16:50

Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a,b,c,d sharing the medium. (a) stations a,b,c,d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful.when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?

Answers: 3

Answer

Computers and Technology, 22.06.2019 23:30

Jaina and tomas are being considered as new tenants in an apartment. the landlord looks at their creditworthiness because he wants to be sure his new tenant pays the rent on time and in full. the table below summarizes the information that was on their applications. application information questions jaina tomas how many years have you had your job? 5 2 what is your monthly salary? $1,850 $2,500 how many credit cards do you have? 4 1 how much debt do you have? $13,000 $7,000 how many times were you late with payments on credit cards in the past year? 5 1 who will the landlord decide to be more creditworthy and why? tomas because the ratio of his debt to income is less. jaina because she has had her job longer, which makes her look more stable. jaina because she has more credit cards available to her. tomas because he makes more money per month.

Answers: 2

Answer

Computers and Technology, 23.06.2019 07:00

Why were most movies from the late 1890s until the early 1930s only filmed in black and white? there were only a few people who could afford the technology to produce color motion pictures back then. audiences did not want color motion pictures until later. the film used to make color motion pictures often overheated, which was a safety hazard, so it was generally not allowed. color films had to be hand-colored, frame by frame.

Answers: 3

Answer

Computers and Technology, 23.06.2019 09:30

Name the range function that would generate the following list of integers values: 0,1,2,3,4,5.

Answers: 1

Answer

You know the right answer?

What command prompts should be used to assign an ip address to:
a - cisco router
b - ci...

Questions