subject
Chemistry, 31.07.2019 05:00 liyahlanderson2861

As you have seen in this lab, the density of water is near 1 g/cm3. anything with a density lower than this will float in water, and anything with a higher density will sink. imagine you are building a submarine. how could you be sure to have it sink and then rise? make sure its density is always above 1.0 g/cm3. make sure its density is always below 1.0 g/cm3. develop a way to adjust its density so that it can be above and below 1.0 g/cm3.

ansver
Answers: 1

Another question on Chemistry

question
Chemistry, 21.06.2019 16:00
Silica, sio2, is formed on silicon as an electrically insulating layer for microelectronic devices. silica is formed when silicon is exposed to o2 gas at an elevated temperature. at 900˚c, it takes 90 minutes for the oxygen to diffuse from the surface to form a 0.06 micron (0.06 x 10-6 m) thick layer of sio2 on
Answers: 1
question
Chemistry, 21.06.2019 22:40
How many electrons does silver have to give up in order to achieve a sido noble gas electron configuration?
Answers: 3
question
Chemistry, 21.06.2019 23:30
Start an single atom tab. observe the decay of polonium-211. after each decay, press the reset nucleus button to watch the process again. write a description of alpha decay for po-211
Answers: 2
question
Chemistry, 22.06.2019 01:00
The diagram shows the positions of the sun, moon and earth during spring tides, when the high tides are at their highest and low tides at their lowest. what is it about these positions that causes these high and low tides?
Answers: 3
You know the right answer?
As you have seen in this lab, the density of water is near 1 g/cm3. anything with a density lower th...
Questions
question
Mathematics, 10.02.2020 23:56
question
Mathematics, 10.02.2020 23:56
Questions on the website: 13722360