HELP PLEASE I HAVE A TEST TODAY AND I DON'T UNDERSTAND ANY OF THIS... 265 kilojoules of energy are added to 150g of ice at 0 degrees C how many grams of water would boil away

About 67 grams or 67.39 grams

Explanation:

First you would have to remember a few things:

 enthalpy to melt ice is called enthalpy of fusion.  this value is 6.02kJ/mol

  of ice  

 it takes 4.18 joules to raise 1 gram of liquid water 1 degree C

 water boils at 100 degrees C and water melts above 0 degrees C

 1 kilojoules is 1000 joules

  water's enthalpy of vaporization (steam) is 40.68 kJ/mol

  a mole of water is 18.02 grams

  we also have to assume the ice is at 0 degrees C

Step 1

Now start with your ice.  The enthalpy of fusion for ice is calculated with this formula:

q = n x ΔH    q= energy, n = moles of water, ΔH=enthalpy of fusion

Calculate how many moles of ice you have:

150g x (1 mol / 18.02 g) = 8.32 moles

Put that into the equation:

q = 8.32 mol x 6.02 = 50.09 kJ of energy to melt 150g of ice

Step 2

To raise 1 gram of water to the boiling point, it would take 4.18 joules times 100 (degrees C)  or 418 joules.

So if it takes 418 joules for just 1 gram of water, it would take 150 times that amount to raise 150g to 100 degrees C.  418 x 150 = 62,700 joules or 62.7 kilojoules.

So far you have already used 50.09 kJ to melt the ice and another 62.7 kJ to bring the water to boiling.  That's a total of 112.79 kJ.

Step 3

The final step is to see how much energy is left to vaporize the water.

Subtract the energy you used so far from what you were told you have.

265 kJ - 112.79 kJ = 152.21 kJ

Again q = mol x ΔH (vaporization)

You know you only have 152.21 kJ left so find out how many moles that will vaporize.

152.21 kJ = mol x 40.68  or   mol = 152.21 / 40.68  = 3.74 moles

This tells you that you have vaporized 3.74 moles with the energy you have left.

Convert that back to grams.

3.74 mol   x  ( 18.02 g / 1 mol ) = 67.39 grams

the correct answer is option d

explanation:

i was wrong its d because they dont use cm when calculating square roots

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.