1. For the reaction 3A — C, the initial concentration of A was 0.2 M, and the reaction rate was 1.0 M/s. When [A] was doubled, the reaction rate increased to 4.0 M/s. Determine the rate
law for the reaction.

Explanation:

Hello there!

In this case, according to the given information for this chemical reaction, it is possible for us to set up the following general rate law and the ratio of the initial and the final (doubled concentration) condition:

Next, we plug in the given concentrations of A, 0.2M and 0.4 M, the rates, 1.0 M/s and 4.0 M/s and cancel out the rate constants as they are the same, in order to obtain the following:

Which means this reaction is second-order with respect to A. Finally, we calculate the rate constant by using n, [A] and r, to obtain:

Thus, the rate law turns out to be:

Regards!

the ideal gas law equation is as follows

pv = nrt

where p - pressure

v - volume

n - number of moles

r - universal gas constant

t - temperature

so if the pressure, volume and temperature are already known

we are left with n and r

since r is the universal gas constant that has a known fixed value then r too is known

so we are left with 'n'

once we know temperature volume and pressure

we can find the number of moles of gas present using the ideal gas law equation

this is not my own answer, this is an answer for the same question by the user blahblahmali. i do not claim ownership of this account.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.