Levi is installing a heat pump. He installed the pipes two feet deep. He then installed the unit within the house and installed a thermostat inside to regulate the heat pump. Lastly, he installed a furnace in the basement. Which best describes Levi’s errors?

The pipes need to be at least six feet deep to avoid the freezing ground, and he did not need to install a furnace.

He did not need to install a furnace, and pipes are not necessary in the installation and function of a heat pump.

Thermostats should be installed directly to the outside unit, and the pipes need to be at least six feet deep to avoid the freezing ground.

Pipes are not necessary in the installation and function of a heat pump, and thermostats should be installed directly to the outside unit.

WHOEVER ANSWERS FIRST AND CORRECTLY GETS BRAINLEST!!! PLEASE HURR

first, consult an activity series chart to determine if al is more reactive than fe. it is, so it will replace the fe. now, one can continue with the problem.

next, make sure you have a correctly balanced equation.

3feo + 2al ==> 3fe + al2o3

now, determine which reactant (feo or al) is in limiting supply.

moles feo present = 125 g x 1 mole/71.8 g = 1.74 moles

moles al present = 25.0 g x 1 mole/26.98 g = 0.927 moles

since from the balanced equation, it take 3 mol feo for every 2 mol al, al will be limiting.

you can determine this simply by dividing moles of each by their coefficient in the balanced equation. for example: 1.74/3 = 0.58 and 0.927/2 = 0.464. al is less, so it is limiting.

finally, using the stoichiometry in the balanced eq. determine mass of fe that can be produced from 0.927 moles of al.

0.927 moles al x 3 moles fe/2 moles al x 55.8 g/mole = 77.6 g

every chemical equation adheres to the law of conservation of mass, which states that matter cannot be created or destroyed. therefore, there must be the same number of atoms of each element on each side of a chemical equation.

answer : third trial had the contaminated sample and the correct value for dhrxn should be 1000 kj/mol

explanation :

let us write down the given equations

equation 1 :

equation 2 :

equation 3 :

let us use hess's law to find out which 2 equations can be added to get the third equation.

let us reverse equation 2 and multiply it by 2. the new equation that we get is,

equation 4 :

let us add equation 1 & 4

the above equation is similar to equation 3 but has different value for dhrxn.

therefore third trial had the contaminated sample and the correct value for dhrxn should be 1000 kj/mol