In a synthesis reaction you start with 1.7L of hydrogen, how many liters of water will be produced

1.7L of water.

Explanation:

Given parameters:

Volume of hydrogen gas  = 1.7L

Unknown:

Volume of water produced  = ?

Solution:

A synthesis reaction is one in which two compounds or molecules combines together to give a product or products.

Synthesis of water from hydrogen gas is represented by the equation below:

                           2H₂    +        O₂     →    2H₂O

We clearly see that;

                       2 mole of hydrogen gas gives 2 mole of water as the product;

From Gay-lussac's law of combining volume "when gases react, they do so in volumes which bear a simple ratio to one another and to the volume of the product if gaseous, temperature and pressure remaining constant".

                2H₂    +        O₂     →    2H₂O

   2 volumes of hydrogen gas will produce 2 volumes of water

  1.7L of hydrogen gas will also produce ; 1.7L of water.

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

a saline water is fed to a reverse osmosis unit at flow rate o rotameter connected to reject (retentate) line reads 8 installed in reject and permeate line reads 15.2 milli siemens/cm and 300 micro siemens/com respectively.