procedure:
1. cut 3 strips of coffee filter. be sure that the strips are much narrower
...
procedure:
1. cut 3 strips of coffee filter. be sure that the strips are much narrower
and slightly taller than the drinking glasses.
2. in the center the strips, about 3 cm from one end, place a dot of the
marker to be tested. the dots should be about 0.2 cm in diameter and
dark enough to be dearly visible.
3. place about 2 cm of water in each glass.
4. tape the unmarked end of each strip to the center of a pencil so that
the strip hangs down when the pencil is held horizontally.
5. carefully insert the strips into the glasses, dotted end down. the dot
must be above the water, and the sides of the coffee filters cannot
touch the sides of the glasses.
6. let the setup stand for 20 minutes. follow procedure 8 as your setup
stands.
7. record your observations after 20 minutes in the table below. measure
d in cm) for the solvent. measure the d. (in cm) for each color that
you see on the coffee filter (there may not be three). calculate the r
for each color using the equation in the introduction section.
8. repeat steps 1-7, except place about 2 cm of isopropyl alcohol
(rubbing alcohol) in each glass instead of water.
9. clean up your work area.
data:
marker color
marker color
d.
colors
d
r
d.
colors
solvent:
water
d. r
d
colors
d
r
d. colors
d. rd colors
d, r
d
colors dr
solvent:
isopropyl
alcohol
(rubbing
alcohol)
Answers: 1
Chemistry, 21.06.2019 20:30
What was the procedure by which case united states vs lopez went to court
Answers: 1
Chemistry, 22.06.2019 21:50
What is a main difference between a mixture and a pure substance? a mixture is only a liquid, but a pure substance can be in any state.a mixture looks the same throughout, but a pure substance does not.1 a mixture can vary in composition, but a pure substance has a set composlo a mixture can be made up of a single compound, but a pure substance car
Answers: 2
Chemistry, 23.06.2019 07:00
Write a hypothesis that answers the lesson question, “while observing a chemical reaction, how can you tell which reactant is limiting? ” hypothesis: if a substance is the limiting reactant, then . . because . .
Answers: 1
Chemistry, 23.06.2019 11:50
How many moles of an ideal gas would occupy a 25.0 liter container when the temperature is 295 k and the pressure is 0.850 atm?
Answers: 2
Computers and Technology, 29.05.2020 02:03
Mathematics, 29.05.2020 02:03
Mathematics, 29.05.2020 02:03
Mathematics, 29.05.2020 02:03
Mathematics, 29.05.2020 02:03