subject
Chemistry, 17.10.2019 20:30 CobyHageman

Unit 1: gases and kinetics
2. the following chemical reaction was performed in lab:
c(s) +2h2(g) - ch (g)
the reaction was performed where methane produced was bubbled through water and
into a eudiometer . as the reaction proceeds, the methane displaces the water inside the
eudiometer and the water escapes into a water bath below the eudiometer. below is the
data table recorded from the experiment.
mass of carbon
0.0114g
height above water level 10.2cm
of water bath
volume inside the
24.35ml
eudiometer
temperature of water 22.98°c
bath before and after
reaction
recorded atmospheric 740 mmhg
pressure
vapor pressure of water 21.1 mmhg
at 22.98°c
density of water at 0.9976 g/ml
22.98°c
density of mercury at 13.534 g/ml
22.98°c
a. if excess hydrogen gas was added to the solid carbon, how many moles of
methane, ch, should be theoretically formed from the reaction? (5pts)
b. based on the data table above, what is the pressure of methane inside the
cudiometer once the reaction is complete? (5 pts)
c. based on the data table above, experimentally determine the amount of moles of
methane formed. how does this value compare to the theoretical amount in a.? (6
pts)
d. which gas, h, h,o, or ch, would be expected to deviate more from ideal gas
behavior? explain your answer. (4 pts)
e. what would the relative ratio of average speed be between h, and h, o? (4 pts)

ansver
Answers: 1

Another question on Chemistry

question
Chemistry, 22.06.2019 07:30
In the particles are arranged in a regular, repeating pattern. a)a crystalline liquid b)a crystalline solid c)all gases d)all solids
Answers: 2
question
Chemistry, 22.06.2019 09:00
Which process does not require the presence of a physical substance in order to transfer heat? air in the atmosphere is heated by the ground. this warm air then rises, and cooler air falls. this is an example of what type of process? how is conduction different from radiation?
Answers: 1
question
Chemistry, 22.06.2019 14:30
Is a pencil falling to the floor anon contact force, a force, or a contact force
Answers: 1
question
Chemistry, 22.06.2019 22:30
Gusing the milligrams of ascorbic acid you entered above, the ratio of total sample volume to aliquot volume, and the total milligrams of the vitamin c tablet that you dissolved, calculate the mass of ascorbic acid in the vitamin c tablet for each trial. do this by scaling up to find the amount (mg) of ascorbic acid in your 250 ml flask. enter your calculated mass of ascorbic acid in the vitamin c tablet, for each trial. be sure to enter your calculated mass in the corresponding order that you entered your milligrams of ascorbic acid. the milligrams of ascorbic acid you entered for entry #1 previously should correspond to the mass of ascorbic acid that you enter for entry #1 here.
Answers: 1
You know the right answer?
Unit 1: gases and kinetics
2. the following chemical reaction was performed in lab:
c(...
Questions
question
Mathematics, 25.03.2020 18:30
question
Mathematics, 25.03.2020 18:30
Questions on the website: 13722363