Chemistry, 28.09.2019 02:30 pacpac1172

An ice cube at 0.00 ˚c with a mass of 8.32 g is placed into 55 g of water, initially at 25 ˚c. if no heat is lost to the surroundings, what is the final temperature of the entire water sample after all the ice is melted (report your answer to three significant figures)?

Answers: 3

Show answers

Answers

Answer from: kat5377

The final temperature of the entire water sample after all the ice is melted, is 12,9°C. We should realize that if there is no loss of heat in our system, the sum of lost or gained heat is 0. It is logical to say that the temperature has decreased because the ice gave the water "heat" and cooled it

Explanation:

This is the begin:

Q1 = Q which is gained from the ice to be melted

Q2 = Q which is lost from the water to melt the ice

Q1 + Q2 = 0

We are informed that the ice is at 0 ° so we have to start calculating how many J, do we need to melt it completely. If the ice had been at a lower temperature, it should be brought to 0 ° with the formula

Q = mass. specific heat. (ΔT)

and then make the change of state by the latent heat of fusion.

The heat of fusion for water at 0 °C is approximately 334 joules per gram.

So Q = Hf . mass

Q1 = 334 J/g . 8.32 g = 2778,88 J

For water we should use this:

Q = mass. specific heat. (ΔT)

Q2 = 55g . 4180 J/kg. K (Tfinal -T initial)

(notice we have kg, so we have to convert 55 g, to kg, 0,055kg so units can be cancelled)

Q2 = 0,055kg . 4180 J/kg. K (Tfinal (The unknown) -25°)

T° should be in K for the units of Specific heat but it is the same. The difference is the same, in K either in °C

25°C = 298K

Q2 = 0,055kg . 4180 J/kg. K (Tfinal -298K)

Now the end

Q1 + Q2 = 0

334 J/g . 8.32 g + 0,055kg . 4180 J/kg. K (Tfinal -298K)

2778,88 J + 229,9 J/K (Tfinal - 298 K) = 0

2778,88 J + 229,9 J/K x Tfinal - 68510,2 J = 0

229,9 J/K x Tfinal = 68510,2 J - 2778,88 J

229,9 J/K x Tfinal = 65731,4 J

Tfinal = 65731,4 J / 229,9 K/J

Tfinal = 285,9 K

Tfinal = 285,9 K - 273K = 12,9 °C

Answer from: Quest

a non redox reaction occurs when there is not a transfer of electrons. for redox reactions, which are reduction-oxidation reactions, a change in the oxidation number occurs. elements that are reduced gain electrons, and elements that are oxidized lose electrons.

explanation:

Answer from: Quest

Wyyeurudydudyeye2y3y3y3ueuudisusuisus7w7uwh2u

Another question on Chemistry

Chemistry, 21.06.2019 17:00

Initially, the balloon had 3.0 liters of gas at a pressure of 400 kpa and was at a temperature of 294 k. if the balloon is cooled to 277 k and its volume decreased to 1 l, what will the new pressure in the balloon be?

Answers: 1

Answer

Chemistry, 22.06.2019 00:30

Lem 2 the data below are for the system ethyl propyl ether (1)-chloroform (2) at 0.5 bar. use the data to answer the following questions (all questions refer to p d 0: 5 bar). a) what are the boiling points of the pure components at 0.5 bar? b) a mixture with the overall composition z1 d 0: 1 is brought to 47.6ä±c, 0.5 bar. what is the phase? c) 100 mole of a mixture with z1 d 0: 1 (state a) is mixed with 22 mole of pure ethyl propyl ether vapor (state b). the mixing takes place at 47.6 ä±c, 0.5. bar. what is the phase of the resulting mixture (state c)? if the state is a v/l mixture report the number of moles and mole fractions in each phase. d) plot the txy graph and show states a, b and c. the graph must be done by computer and should be properly annotated. ethyl propyl ether (1) - chloroform (2) at 0.5 bar t ( ä±c) x1 y1 t ( ä±c) x1 y1 42.9 0.000 0.000 49.0 0.470 0.455 43.0 0.020 0.010 49.1 0.520 0.520 43.9 0.065 0.029 48.9 0.567 0.592 45.4 0.156 0.089 48.3 0.652 0.720 46.4 0.215 0.142 47.6 0.745 0.815 47.6 0.296 0.223 46.7 0.822 0.872 48.3 0.362 0.302 45.7 0.907 0.937 48.7 0.410 0.375 44.6 1.000

Answers: 3

Answer

Chemistry, 22.06.2019 02:00

Write a hypothesis that answers the lesson question, “while observing a chemical reaction, how can you tell which reactant is limiting? ” hypothesis: if a substance is the limiting reactant, then . . because . .

Answers: 1

Answer

Chemistry, 22.06.2019 13:00

Lab reagent, hypothesis test.a reference solution used as a lab reagent is purported to have a concentration of 5 mg/dl. six samples are taken from this solution and the following concentrations are recorded: (5.32, 4.88, 5.10, 4.73, 5.15, 4.75) mg/dl.these six measurements are assumed to be an srs of all possible measurements from solution.they are also assumed to have a standard deviation of 0.2, a normal distributin, and a mean concentration equal to the true concentration of the solution.carry out a significance test to determine whether these six measurements provide reliable evidence that the true concentration of the solution is actually not 5 mg/dl.

Answers: 1

Answer

You know the right answer?

An ice cube at 0.00 ˚c with a mass of 8.32 g is placed into 55 g of water, initially at 25 ˚c. if no...

Questions