Chemistry, 24.09.2019 19:10 evansh78

The effectiveness of the shell & tube heat exchanger improves by:
a- increasing the number of tubes.
b-increasing the diameter of exsisting tubes.
c-reducing the length of existing tubes.
d- both by increasing the number of tubes & increasing the diameter of existing tubes

Answers: 2

Show answers

Answers

Answer from: Quest

there is none because earth is stationary and flat.

Answer from: Quest

definition

entropy is a measure of the randomness or the extent of disorder of a chemical process.

enthalpy is a measure of the heat change of a reaction occurring at a constant pressure.

measurement units:

entropy is measured in joule per kelvin (jk⁻¹) whereas enthalpy is measured in joule per mole (jmol⁻¹)

requirements:

entropy has no requirements or limits, and its change is measured by the division between the heat change of the chemical process and the temperature.

in contrast, enthalpy can only be related to the heat change of the reaction under standard conditions.

Answer from: Quest

i think its 100

i hope this !

Answer from: Quest

Note that 2 mol dm⁻³ = 2 mol/(dm³)outline: we're given the concentration of hcl, which is 2 mol dm⁻³ (cubic meters in the denominator can represent volume, so i know this is concentration). we're an amount of calcium carbonate caco₃, which is 5 g. we're presented with a chemical equation which includes caco₃ and hcl. we are told to find the volume of hcl. from what we see so far, this seems to be a stoichiometry problem. we'll have to use the given information about calcium carbonate to find the amount of moles of hcl needed to fully react with calcium carbonate. then we'll have information about the moles of hcl and the concentration of hcl; that will be enough to figure out volume according to the formula concentration = moles / volume.======all the answer choices are not in dm.convert the given concentration so that it uses cm⁻³.we can use conversion factors. we have to cube our conversion factors so that dimensional analysis works.we can convert to meters first, using the fact that 10 dm = 1 m ⇔ 10³ dm³ = 1 m³then we use the fact that 10² cm = 1 m ⇔ (10² cm)³ = (1 m)³ ⇔ 10⁶ cm³ = 1 m³so converting: $\dfrac{\text{2 mol}}{\text{dm}^{3}} \cdot \dfrac{\text{10}^3\text{ dm}^3}{\text{1 m}^3} \cdot \dfrac{\text{1 m}^3}{10^6\text{ cm}^3} \\ \\ = \dfrac{\text{2 mol}}{1} \cdot \dfrac{\text{10}^3}{1} \cdot \dfrac{1}{10^6\text{ cm}^3} \qquad \text{\footnotesize cancelling units} \\ \\ = \dfrac{2\text{ mol}}{10^3 \text{ cm}^3} \\ \\ = 0.002\text{ mol/cm}^3$ now we have to find the moles of hydrochloric acid neededfind the moles of calcium carbonate. we have to find the molar mass of calcium carbonate, caco₃, which can be found by molar mass = (mass ca) + (mass c) + 3(mass o) = 40 + 12 + 3(16) = 100 g/molconvert the given 5 g to moles: mol caco₃ = 5 g caco₃ * 1 mol/(100 g) = 0.05 mol caco₃use stoichiometry (ratios) to figure out the moles of hcl needed. ratio wise, there's 2 hcls for every caco₃, so use dimensional analysis mol hcl = mol caco₃ * (2 mol hcl) / (1 mol caco₃) = 0.05 mol hcl * 2 = 0.1 mol hcl we have 0.1 mol hcl and concentration of hcl (0.002 mol/cm³).we need to find volumesince concentration = moles / volume, rearrange to get volume = moles / concentration volume = 0.1 mol / (0.002 mol/cm³) volume = 50 cm³

Another question on Chemistry

Chemistry, 22.06.2019 08:40

For each of the following compounds, write the formula then predict whether it would be a strong, weak, or non-electrolyte when placed in di water. for the ionic compounds only, put (s) or (aq) after the forrmula formula strong, weak or non electrolyte? a calcium hydroxide b. silver carbonate c. lead(ii) sulfate d. phosphorus trifluoride e. sodium phosphide f barium sulfate g. strontium acetate h. zinc nitrate

Answers: 3

Answer

Chemistry, 22.06.2019 12:10

|using the periodic tablewarm-upuse the periodic table in the tools bar to answer the following questions.what elemental classification does oxygen belongto? done

Answers: 3

Answer

Chemistry, 22.06.2019 19:00

Convert the temperature of dry ice, –77 ∞c, into degrees fahrenheit and kelvin.

Answers: 2

Answer

Chemistry, 22.06.2019 19:40

What is the wavelength of a 3*10^12 hz infrared wave a 3*10^20m b 1* 10^4m c 3*10^-3m d 1*10^-4 m

Answers: 1

Answer

You know the right answer?

The effectiveness of the shell & tube heat exchanger improves by:
a- increasing the numb...