Select all steps below that you followed to practice laboratory safety during the experiment. used tongs or a test tube holder to hold materials over the bunsen burner flame wore gloves and goggles made careful observations of the products and reactants did not smell the gases produced

Explanation:

Steps followed to practice laboratory safety during the experiment are as follows.

When we heat a test tube over bunsen flame then the tube gets hot and when we hold it with bare hands then out hands will burn. Therefore, it is advised to hold test tube with the help of tongs or a holder so that our hands did not burn.

We should also wear gloves and goggles so that any acid would not spill directly on our hands, skin and eyes as it can affect or damage the skin severely.

Careful observations were made so that correct calculations about the experiment can be carried out.

It is also advised that we should not smell the gases produced but gases move freely from one place to another in a laboratory or any where else.

So, we can try to avoid it by covering our mouth with a cloth but we cannot stop it. If we keep on inhaling the gases produced in a laboratory then it can also lead to severe disease or defect in the human body.

"you start with 15.67 g mgco3-xh2o, when heated and all the water is removed, you are left with 7.58 g mgco3 only.

therefore, you had 15.67 - 7.58 = 8.09g h2o  

moles of each :

7.58g mgco3 = ? moles = 7.58g / 83.4g/mole = 0.09moles  

8 09g h2o = ? moles = 8.09g / 18g/mole = 0.44moles  

molar ratio between the two by dividing both numbers by the smallest number :

0.09 / 0.09 = 1  

0.44 / 0.09 = 4.8  

mgco3-5h2o"