Technician a states that the torque-to-yeild method is one of the primary methods of replacing wheel lug studs. technician b states that the arc welder method is one of the primary methods of relacing wheel lug studs. who is correct?

Wheel lug studs makes the changing of tires easy by creating the ability to hold  and locate the assembly in the changing of tire through lifting both tire onto the studs and also the wheel. The technician that states that torque-to-yield method is one of the primary method in replacing   wheel lug studs is correct.

Wheel studs are threaded fasteners that holds on the wheel and doing re-torque of lug nuts that is fully assembled to the wheel stud is applied, then pull it a few times and seal it to secure the wheel. Then check the torque after a test drive to ensure safety.

Moreover, wheel studs are replaceable; it has two types, the press-in, and screw-in method. Nevertheless, the arc welder method is possible but unlikely to be used.

 

 

The federal reserve took an expansionary approach during the crisis. this was done by expanding the money supply and boosting liquidity. this can be seen in the fed's actions of lending to banks, purchasing securities, and lowering the federal funds rate in order to lower overall interest rates. the fed's goal was to increase consumer spending and overall liquidity within the system, and they pursued this by expanding the supply of liquid money.

There is no graph so we cannot answer