Business, 26.11.2019 05:31 saraaaaaaaa20

Eric has another get-rich-quick idea, but needs funding to support it. he chooses an all-debt funding scenario. he will borrow $2 comma 000 from wendy, who will charge him 6% on the loan. he will also borrow $1 comma 500 from bebe, who will charge him 8% on the loan, and $800 from shelly, who will charge him 14% on the loan. what is the weighted average cost of capital for eric?

Answers: 1

Show answers

Another question on Business

Business, 21.06.2019 20:30

Which of the following statements is correct? a) one drawback of forming a corporation is that it generally subjects the firm to additional regulationsb) one drawback of forming a corporation is that it subjects the firms investors to increased personal liabilitiesc) one drawback of forming a corporation is that it makes it more difficult for the firm to raise capitald) one advantage of forming a corporation is that it subjects the firm's investors to fewer taxese) one disadvantage of forming a corporation is that it is more difficult for the firm's investors to transfer their ownership interests

Answers: 1

Answer

Business, 22.06.2019 17:30

One of your new suppliers, kim, has been hearing rumors about your firm’s lack of capability to deliver high quality products and writes an email asking you to address the claims being made. in replying to her, you want to be sure that you are very clear and leave no room for misinterpretation. which of the following aspects of effective communication should you give the most attention? (a) making sure you understand kim’s areas of expertise. (b) supporting your reply with relevant data and facts. (c) establishing your credibility as an expert. (d) paying attention to implied communications.

Answers: 2

Answer

Business, 22.06.2019 18:00

What is the cause of smoky exhaust?

Answers: 1

Answer

Business, 22.06.2019 21:50

Q3. loral corporation manufactures parts for an aircraft company. it uses a computerized numerical controlled (cnc) machining center to produce a specific part that has a design (nominal) target of 1.275 inches with tolerances of ± 0.020 inch. the cnc process that manufactures these parts has a mean of 1.285 inches and a standard deviation of 0.005 inch. compute the process capability ratio and process capability index, and comment on the overall capability of the process to meet the design specifications.

Answers: 1

Answer

You know the right answer?

Eric has another get-rich-quick idea, but needs funding to support it. he chooses an all-debt fundin...

Questions