7. Does snow leopard A have a longer tail
than snow leopard B. Which term is
used to describe the difference
between them?
Page 364

Consider the motion of the balloon and its air contents in terms of momentum. in step 1 above, the total momentum of the balloon and its contents was zero. recall that momentum = mv. both the balloon and the air inside it had a velocity of zero and therefore the total momentum was zero. now think about what happened when the air escaped from the balloon. a certain mass of air accelerated in one direction. in order to keep the total momentum of the system zero, the balloon itself (which has mass) had to accelerate in the opposite direction. use this scenario to you explain why the soda can rotates when the water squirts out of the escape holes. what was your hypothesis concerning the water-filled can? according to your data, do you think your hypothesis was correct? (be sure to refer to your data when answering this question.) summarize any difficulties or problems you had in performing the experiment that might have affected the results. describe how you might change the procedure to avoid these problems. give at least one more example of newton's third law in everyday life.

Which of the following was a characteristic of a dromaeosaur? modified front claw grasping with their forelimbs both a and b none of the above

Astudent from one of the research labs is having trouble preparing a slide for examination and photographing. the bacterial slide that he has brought to you was prepared using a commercially purchased stain. he has asked for your in determining what he is doing wrong so that he can change the lab protocols and continue on with his project. after examining the slide under oil immersion, you determine that no bacteria are present even though the student is able to show you the culture he used to make that slide that has visible growth in the liquid medium. which of the following statements does not explain the fact that there are no bacteria present on the student’s slide? by not allowing a glass slide to completely air dry before heat fixation, the flame will cause the surrounding water to boil and this will damage the bacterial cell. overheating during the fixation step boiled the water within the bacterial cells and resulted in the cells bursting. insufficient heating of the slide did not drive out the thin layer of water and this resulted in minimal bonding between the bacteria and the glass slide. rinsing with alcohol during the washing step stripped the bacteria off the glass slide. rinsing with alcohol during the washing step stripped the bacteria off the glass slide.